Furnace

PILOT LIGHT

    • Remove Front Cover
    • Are there little tabs at the top of the furnace?
    • If there are little tabs on top that look like they fit a Flat Head Screw Driver, turn both so that the Flat Crease is horizontal to the floor.
    • Push against the top cover of the furnace and at the same time push upward.
    • Grab a long match or long stem lighter
    • Look for a button that says “Pilot”
    • Push and HOLD the button while placing the lighter in the center of the furnace
    • While the pilot light is still on, keep holding the “Pilot Light Button” for 30 seconds.
    • If you DO NOT hold the button down long enough, the heat sensor will turn off the gas to the pilot light.  You will have to start the process over again.
    • Place the front cover back on the SAME WAY that you took it off.
    • Make sure that the lower cover is not lose because this will prevent the blower from turning on.  The blower is what allows the air to circulate through the house.

      FRONT COVERS

      • “Have you changed the filter recently?”
      • Here is how you remove the front cover
      • Remove Front Cover
      • Are there little tabs at the top of the furnace?
      • If there are little tabs on top that look like they fit a Flat Head Screw Driver, turn both so that the Flat Crease is horizontal to the floor.
      • Push against the top cover of the furnace and at the same time push upward.
      • Place the front cover back on the SAME WAY that you took them off.
      • Make sure that the lower cover is not loose because this will prevent the blower from turning on.  The blower is what allows the air to circulate through the house.